TGX GM ( former XLX ) Cupboard inst. of 2nd bed
Cupboards / Cabinets fitting in M.A.N. TGX GM ( former XLX ) Cupboard inst. of 2nd bed TGX GM ( former XLX ) Cupboard inst. of 2nd bed Here in Licht Grey HPL with Extra towel rod and 2 keylocks on the outher doors Cupboard fitting in the back wall of the M.A.N. TGX GM ( former XLX ) Cupboard inst. of 2nd bed This Cupboard is over the entire width of the cab, and is performed in a u shape. The Cupboard is divided into 4 compartments and equipped with 4 doors with push button closures, (also key locks possible extra charge €15 excl VAT per piece). in the middle 2 compartments is also a shelf. The Cupboard is in the middle plus minus 32 cm deep, to the outsides. The Cupboard is plus minus plus minus 48 cm deep and plus minus 50 cm high, and weighs 28 kg empty. Lightweight material is used for the manufacture of the cupboard, so that it is not heavier than the bed that is removed from the vehicle. To assemble this cupboard 10 pcs. 5 mm thick self-drilling screws are used that enter the reinforced parts in the side walls and rear wall of the cab and with 4 bolts to the existing suspension points in the roof. cupboard open Here in Licht GreyHPL Here with Inserts Here in Beige HPL with black Edges here With Silver Edges and Towel rod In Black HPL With Black edges. In Black HPL With Silver edges. and towel bar This is what the Cabin should look like in which this cupboardwill be placed: The cupboard is, among other things, attached to the suspension points of the 2nd bed, so these points must be present Side wall Passenger side Back wall Attachment points in the roof Side wall Steering side The Dometic MW024 Roadmate microwave on 24 volt fits in this Cupboard, and can be ordered on the same order form as the Cupboard.
Available in 6 colors HPL (hard plastic laminate) Available in 18 colors leather look Available with Black, Silver or Bronze Edge Finish This new Color Leatherlook R = Taupe also fits well with the new MAN Interior
Prices: Cupboard of which the doors, side pieces and top strip are covered with smooth leather look. The visible side of the bottom is in black HPL or at an extra charge in leather look or velvet. €: 730,-excl vat Cupboard of which the doors, side pieces, top strip and visible side of the bottom are covered with the color of your choice HPL (hard plastic laminate) €: 760,-excl vat Cupboard of which the doors, side pieces and top strip are covered with smooth Fabric. The visible side of the bottom is in black HPL or at an extra charge in leather look or velvet. €: 800,-excl vat View side bottom with smooth leatherlook or smooth fabric: from €:50,- excl vat Sheet for under the cupboard with 4 cm thick polyether and leatherlook or velvet with buttons from € 150,- excl VAT Led lights in the plate under the cupboard from € 90 excl. VAT. Choose from 5 0f 10 pieces in Red, Blue, Green, Cool White. Inserts in doors in leather look: from € 125,- excl VAT Printed motif on doors or inlays in doors in leather look €: 16.53 excl. VAT per item. Your own photo is also possible Embroidery on Doors, Valves or inlay in Doors in leather look or Fabric €: 24,79 excl. VAT per item. Possible motives: Engraving on Doors, Valves in HPL €: 20.66 excl. VAT per item. 4 Led Lights in the top Strip on the front of the Cabinet, Choice of Red, Blue, Green or Cool White. €: 72,- excl VAT Towel Hanging Rod €: 29,- excl. VAT for the top strip or bottom of the cupboard. Set of cover plates that cover the openings where the 2nd bed has been €: 15,- excl. VAT You can install this cabinet yourself with the help of our extensive manual Or have us installed in Emmeloord Netherlands Required installation time for mounting by BCM is approximately 1 to 1.5 hours. All prices on this page EXCLUDING V.A.T. We disclaim that the articles shown here are produced by Ben’s Cabinemeubels, and not by the relevant truck manufacturer, but only made appropriate to the individual truck.
|